Main Unit Field Service Malfunction code
4-23
IV
Troublshooting
2.4.22 C013: MAC address error (Only for magicolor 5450)
C015: BOOT ROM error (Only for magicolor 5450)
C022: NVRAM error (Only for magicolor 5450)
2.4.23 C025, C026, C027: Controller ROM error (Only for magicolor 5450)
Relevant Electrical Parts
Print Control Board (PWB-P)
Step Action
WIRING DIAGRAM
Control Signal
Location
(Electrical
Component)
1
Turn OFF the Power Switch of the printer and
turn it ON again (Restart of the printer.)
--
2
Check the PWB-P connector for proper connec-
tion and correct as necessary.
--
3 Change PWB-P. - -
Relevant Electrical Parts
Print Control Board (PWB-P)
Step Action
WIRING DIAGRAM
Control Signal
Location
(Electrical
Component)
1
Turn OFF the Power Switch of the printer and
turn it ON again (Restart of the printer.)
--
2
Check the PWB-P connector for proper connec-
tion and correct as necessary.
--
3
If this error message is displayed after update of
firmware, conduct the firmware update proce-
dures again.
--
4 Change PWB-P. - -
5450_E.book_PDF.book 23 ページ 2005年4月12日 火曜日 午後12時54分
Kommentare zu diesen Handbüchern