Konica-minolta Polygon Editing Tool Bedienungsanleitung PDF herunterladen (Seite 126)

124

Chapter

File

300

File – Import – Digitizer – Step Scan (When VIVID 300 is Selected)

Enter the desired element name, and

set parameters.

Click the [OK] button.

Fine-registration of the element position will

be performed and the data will be displayed

again.

• If a rotating stage has been selected by the Turn-

table, the stage will turn to the next angle and

then scan will be performed.

• Select the desired rate from “1/1”, “1/4”, “1/9”,

“1/16” and “No polygon” by selecting from the

[Reduction Rate] pull-down menu.

• If you want to generate points to ll in holes caused

by missing data, set the [File Holes] setting to “On”.

• The [Remove] pull-down menu lets you select

which points to remove from the imported data.

You can set this to any of the following: “None”,

“Boundary(B.)”, “5deg. & B.”, “10deg. & B.”,

“15deg. & B.”, or “20deg. & B.”

• If you want to lter the imported data, select the

appropriate parameter from the [Filter] pull-down

menu.

• To save the raw scan data (.cam) when importing

data, check the [Save camera data] checkbox.

Note

Theelementnamemustconsistofupto31characters.

Click the [OK] button.

Each scanned image will be subjected to reg-

istration and displayed, and the “Proceed to

registration?” message dialog box will appear.

The element list will also show the element

name specied at step 11 plus “rotation step”.

The element name is highlighted, indicating

that it is currently selected.

• The loaded data will be ready to be displayed in

all windows. It will be displayed in the active

window and the windows for which all the ele-

ments are set to be displayed.

• When the data is loaded for the rst time after

the software is started, it will be fully framed in

all the windows including those that are hidden

automatically.

• If a rotating stage has been designated, the rotat-

ing stage will rotate back to the original position

before data reading starts.

• If the [Save camera data] checkbox was checked

at step 11, the [Remote-Save] dialog box will ap-

pear before the one that asks whether you want to

perform ne-registration.

q Enter the desired le name.

w Click the [Save] button.

Note

Thelenamemustconsistofalphanumericcharacters

only.

• If you are not going to perform ne-registration,

click the [Cancel] button instead of the [OK] but-

ton.

emo

Fine-registration can be cancelled even if it has started, by

clicking the [Cancel] button in the dialog box that appears

during ne-registration.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 269 270

Kommentare zu diesen Handbüchern

Keine Kommentare

Konica-minolta Polygon Editing Tool Bedienungsanleitung Seite 126

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Konica-minolta Polygon Editing Tool