Konica-minolta Polygon Editing Tool Bedienungsanleitung PDF herunterladen (Seite 201)

199

Chapter

Build

910

900

700

300

n Rotating the Element(s) by Entering a Value Directly

To rotate the element(s) by specifying the rotating angle, follow the procedure given below.

Note

If Build – Rotate – Elementsmodewasactivatedusingtheshortcutkey,theelement(s)cannotbemovedbythismethod.

Operating Procedure 　

The following steps must be carried out in Build – Rotate – Elements mode.

Click the right mouse button.

The [Build-Rotate-Elements] dialog box will

appear.

Select X, Y or Z to be used as the pivot,

and enter the desired rotating angle.

Click the [Apply] button.

The selected element(s) will rotate by the

specied angle.

• If you change the angle and click the [Apply]

button, the element(s) will rotate again according

to the new angle. The new angle will not be added

to the previous angle. It is an absolute angle from

the original position.

Click the [OK] button.

The [Build-Move-Points] dialog box will close,

movement of the point(s) will be conrmed,

and the Build-Move-Points mode will be

canceled.

• Clicking the [Cancel] button will cancel all the

operations that have been performed since the

dialog box was opened.

Build – Rotate – Elements

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 269 270

Keine Kommentare

Konica-minolta Polygon Editing Tool Bedienungsanleitung Seite 201