Konica-minolta Polygon Editing Tool Bedienungsanleitung PDF herunterladen (Seite 190)

188

Chapter

Build

910

900

700

300

n Moving the Point(s) by Entering Values

To move the point(s) by specifying how much they must be moved, follow the procedure given below.

Note

IfBuild – Move – Points modewasactivatedusingtheshortcutkey,thepoint(s)cannotbemovedbythismethod.

Operating Procedure

The following steps must be carried out in Build – Move – Points mode.

Click the right mouse button.

The [Build-Move-Points] dialog box will ap-

pear.

Enter the desired amount of movement

for X, Y and Z.

The amount can be entered for all the axes at

the same time.

Click the [Apply] button.

The selected point(s) will move according to

the values entered.

• If you change a value(s) and click the [Apply]

button, the point(s) will move again according to

the new value(s).

New values will not be added to the previous

values. They are absolute values from the original

position.

Click the [OK] button.

The [Build-Move-Points] dialog box will close,

movement of the point(s) will be conrmed,

and the Build-Move-Points mode will be

canceled.

• Clicking the [Cancel] button will cancel all the

operations that have been performed since the

dialog box was opened.

Build – Move – Points

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 269 270

Keine Kommentare

Konica-minolta Polygon Editing Tool Bedienungsanleitung Seite 190