Konica-minolta Polygon Editing Tool Bedienungsanleitung PDF herunterladen (Seite 52)

Chapter

File

910

File – Import – Digitizer – One Scan (When VIVID 910 is Selected)

Performing One Scan with the VIVID 910

This command is used to cause the VIVID 910 (VI-910) to scan the object one scan at a time using the remote

control function of this software. Registration of multiple scan data can be performed by manually designating

their corresponding points.

Warning

Never stare into the laser emitting window.

Do not place a lens, mirror or optical element in the passage of the laser beam. Doing so may converge the

laser beam, resulting in damage to your eyes, burns or re. To prevent the above accidents, make sure that a

wall or similar which can block the laser beam is located behind the object.

emo

Before performing the procedure below, make sure that

the digitizer you are going to use is selected by the File

– Select Digitizer command.

Ref.

For details of the File–SelectDigitizercommand,

refer to page 144.

Operating Procedure

From the [File] menu, select [Import],

[Digitizer] and then [One Scan].

The [File-Import-Digitizer-One Scan] dialog

box will appear.

• The monochrome monitor image captured by the

VIVID 910 will appear in the Work window area

of the dialog box.

To display the object in the middle of the

Work window area , change the posi-

tion of the object or move the instrument

back and forth to change the view angle.

Set an object in place.

If you are going to use the rotating stage,

place the object on it.

emo

If necessary, replace the lens attached to the VIVID.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 269 270

Keine Kommentare

Konica-minolta Polygon Editing Tool Bedienungsanleitung Seite 52